Hi. So it's been so long since the last chapter that I don't remember much so maybe there's better examples to post I don't know. But here's some things:
In general Berserk has much better raws for its magazine releases than like Naruto or Bleach. And they've been especially good recently. Most of the work is cleaning the shity paper/ink quality like this:
-dirty:
http://i.imgur.com/6s0zXer.png
-clean:
http://i.imgur.com/Klu6RkA.png
It can be hard to tell between what details are and aren't supposed to be there.
But sometimes the raws are shit quality, and we could spend a ton of time and make it nicer, but it's just not worth the time.
-raw from chapter 328:
http://i.imgur.com/mUpUlmu.png
-finished page, isn't much better:
http://i.imgur.com/onBwmz1.png
-and the volume quality raw:
http://i.imgur.com/j54RK3b.png
This was probably the derpyest thing, at least since I've been helping edit Berserk. Normally the middle of a 2 page spread is pretty close and not too torn, but here it was pretty bad and I had to draw Guts' shoe-armor and some monster bits:
-derp:
http://i.imgur.com/X4fO2Bd.png
-un-derp:
http://i.imgur.com/MlYVBaK.png
-In the volume raw you can see that I drew it wrong:
http://i.imgur.com/EpmFdc3.png
We don't replace sfx usually unless they're inside a speech bubble, but they're not very complicated in Berserk, so here's an example from Zetman so that I can show off more:
-Original text:
http://i.imgur.com/J0R5cxu.png
-Removing original text and drawing in where it went outside of the bubble:
http://i.imgur.com/CrRM50u.png
-Derpily laying out where the english text should go:
http://i.imgur.com/9N3qOzP.png
-Drawing in the shape of the text, and disregarding the derp layout if it didn't really go as planned:
http://i.imgur.com/w903pEA.png
-Making a copy of the original layer and using the clone stamp tool to graft the texture onto the english text:
http://i.imgur.com/6kuoroj.png
-Adding black lines around everything and white lines where it goes outside the bubble:
http://i.imgur.com/GVMu8V9.png
